-
1.23.1
BlastIQ Mobile
3rd of September 2024
- Version 1.23.1 will be offered to users in September 2024. A notification will appear in BlastIQ Mobile on start-up once the update is available. We hope this will enable customers to perform the update without assistance from the specialist.
- For further information on an update to the software, please contact the Support Team at blastiqsupport@orica.com or via web support.blastiq.com.
-
New
-
- Multiple Hole Comments. Read more here.
Note: This feature is supported by BlastIQ™ Insights for Open Cut and Quarries operations and by BlastIQ™ Underground desktop for Underground operations. SHOTPlus™ is currently working on a version that supports it.
- Measure Water After Backfill or Stand-off. Read more here.
Note: This feature should not be turned on until the site fully updates to a SHOTPlus™ version that supports it. SHOTPlus™ is currently working on a version that supports these measurements.
- Next to Load - Open Cut. Read more here.
- Multiple Hole Comments. Read more here.
-
Improved
-
- On the loading map, clicking anywhere outside the hole's boundary will un-select the selected hole.
- In surface, added new pre-defined comments "Top loaded & Collar pipe."
-
Fixed
-
- The deck weight calculation API call sends incorrect horizon value when in imperial mode.
- The deck is not overloaded, but the deck warning shows "Deck has been overloaded according to design" when the units of measurement are set to "Imperial."
- In surface, there is no spacing between the delete and abandon hole buttons.