How to Create a Template in SHOTPlus

1. Open SHOTPlus and start a NEW file.

2. Edit the blast properties to suit your requirements:

a. sp6.png

b. sp7.png

c. The most important information to set up in this menu for a starting template is: blast header information, hole states (especially when using DIPPlus units), hole types if you require specific names (e.g. front row, body, pre-split) and loading chart options.

3. Edit the design data to suit your requirements.

a. sp8.png

b. sp9.png

c. Set this information up for each hole type you will be using. This can also be saved as a separate file if required

4. Edit the available resources to suit your requirements.

a. sp10.png

b. sp11.png

c. This information can also be saved as a separate scheme if required.

5. Set up Loading Rules.

a. sp12.png

b. sp13.png

6. Set up any monitoring points required.

a. sp14.png

b. sp15.png

7. Import any required .dxf such as strips and blocks, points of interest.

8. Save the template. File, Save as Template.

2017-05-22_13_42_38-.png

sp17.png

9. The template will then be available for use when you start a new shot.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request